HMI Proface GP-4503T / Model: PFXGP4501TADW 

10.4-inch TFT Color Touch Screen Operator Interface

Features HMI Proface GP-4503T  :

• 65,536 Colors, Clear, Bright, High-Resolution TFT Display
• Energy Effecient LED Display
• No Grid Analog Touch Panel for Improved Visibility and Precise Part Placement
• Supports Up to Two Protocol Drivers Simultaneously
• High Speed Application Transfer, 10 Times Faster than Conventional Operator Interfaces
• 10/100 Base-T Ethernet, USB, Serial Communication, and SD Card Interfaces
• High-Definition Part Images and Multi-Language Support

Specifications HMI Proface GP-4503T :

1.) Up to 60,000 steps can be converted in software. However, this reduces application memory capacity (for screen data) by 1 MB.

2.) Depending on the operating temperature and age of unit, the clock can deviate from -380 to +90 sec/month. For systems where this level of deviation is a problem, the user should monitor and make adjustments when required.

General Specifications HMI Proface GP-4503T :

3.) The front face of the GP unit, installed in a solid panel, has been tested using conditions equivalent to the standards shown in the specification. Even though the GP unit’s level of resistance is equivalent to these standards, oils that should have no effect on the GP can possibly harm the unit. This can occur in areas where either vaporized oils are present, or where low viscosity cutting oils are allowed to adhere to the unit for long periods of time. If the GP’s front face protection sheet becomes peeled off, these conditions can lead to the ingress of oil into the GP and separate protection measures are suggested. Also, if non-approved oils are present, it may cause deformation or corrosion of the front panel’s plastic cover. Therefore, prior to installing the GP unit, be sure to confirm the type of conditions that will be present in the GP’s operating environment. If the installation gasket is used for a long period of time, or if the unit and its gasket are removed from the panel, the original level of the protection cannot be guaranteed. To maintain the original protection level, be sure to replace the installation gasket regularly.

4.) Regarding dimensional tolerance, everything +1/-0 mm [+0.04/-0 in.] and R in angle are below R3 [R0.12 in.]. Even if the installation wall thickness is within the recommended range for the “Panel Cut Dimensions”, depending on wall’s material, size, and installation location of GP unit and other devices, the installation wall could warp. To prevent warping, the installation surface may need to be strengthened.