DAT 100/ANALOG weight transmitters Pavone Sistemi

High performance and long-term reliability
Assembly “snap-on” DIN rail (EN50022)
ANALOG output
Configuration and calibration from the front panel executable with certificates of transducers, or with dead weights
2 logic inputs and 2 relay outputs
Serial RS232 output, ASCII protocols and Modbus RTU
The dimensions of width contained allow to place a large number of transmitters within the electrical panels automation
Interfacing with intrinsically safe barriers for use in hazardous areas

TECHNICAL CHARACTERISTICS DAT 100/ANALOG

Trasducer input voltage:	4 V (max 4 cells 350 Ohm)
Measuring range:	–4 ÷ +4 mV/V
Rated load (R.L.):	0.02 V/division
Linearity:	< 0.01% FS
Gain drift:	< 0.001% FS/°C
Display:	5 digit, red LED (7 segments), h 7 mm
LED status:	2 red
D/A convertitor:	24 bit
Internal resolution:	16.000.000 counts
Visible resolution:	60.000 division visible on net weight
Divisions value (adjustable):	0.001÷50
Filter:	0.2÷25 Hz adjustable
Keyboard:	3 mechanic buttons (under the red window)
Tool voltage:	24 V c.c. ±10% – power 2 W
Temperature range:	-10 ÷ +50°C
Storage Temperature:	-20 ÷ +60°C
Logic output:	2 Solid-state relays, (maximum load 24 Vdc / 100 mA each)
Logic input:	2 optoisolated 24 V c.c. PNP (External voltage)
Serial door:	RS232C half duplex with ASCII or Modbus RTU protocol, RS485 full duplex with ASCII or Modbus RTU protocol
Baud rate:	2400 ÷ 115200 adjustable
Trasmission distance:	15 m
Analogic output:	16 Bit optoisolated
Tension:	0÷5/10V (R min10 K Ohm)
Current:	0/4÷20mA (R max 300 Ohm)
Linearity:	< 0.03% FS
Gain drift:	< 0.002% FS
Regulatory compliance:	EN61000-6-2, EN61000-6-3 for EMC; EN61010-1 for electrical security
Electrical connection:	Terminal screw pass 5.08 mm

Accessories are not to be considered included in the price of each product.
All the above is purely illustrative and not to be understood demanding towards Pavone Sistemi